Keysight M9421A - Page 35

Table Of Contents
Edit 11ax/be Limit 1269
Relative Constellation Error in common 1269
Relative Constellation Error in trigger-based PPDU > max power of MCS7 1271
Relative Constellation Error in trigger-based PPDU power <= max power of MCS7 1273
MCS of Trigger-based PPDU 1275
DCM of Trigger-based PPDU 1276
Max Power of MCS7 1277
3.7.9.9 Advanced 1277
PhNoise Opt 1277
LO Dither 1279
IF Gain 1280
Other IF Gain 1281
FFT SEM Enable 1282
FFT Acquisition Time(Remote Command Only) 1282
FFT SEM Trigger Delay (Remote Command Only) 1282
Enable FFT SEM Offset D (Remote Command Only) 1283
FFT SEM Multi-Burst (Remote Command Only) 1283
Cross-Correlated EVM 1284
Power Reference Plane 1284
Min Idle Time 1285
3.7.9.10 Global 1286
Remote Analyzer Config 1286
IP Address 1286
SCPI Socket Port 1286
Add Analyzer 1286
Verify Highlighted Analyzer 1287
Select Highlighted Analyzer 1288
Release Highlighted Analyzer 1289
Release All (Remote Command Only) 1289
Delete Highlighted Analyzer 1290
Delete All 1290
Query Analyzer Information (Remote Command Only) 1290
Query All Analyzer IP Addresses (Remote Command Only) 1291
Query remote analyzer MIMO capability (Remote Command Only) 1291
Select RFIO Input Port Mode (Remote Command Only) 1292
Set RFIO Input Port (Remote Command Only) 1292
Restore Defaults 1293
3.7.9.11 MIMO Result Stream Index (Remote Command Only) 1293
3.7.9.12 MIMO Result Channel Index (Remote Command Only) 1293
3.7.9.13 MIMO Result Segment Number (Remote Command Only) 1294
3.7.9.14 MIMO EVM Multi-Burst (Remote Command Only) 1294
3.7.9.15 MIMO EVM Filter Short State (Remote Command Only) 1295
3.7.10 Sweep 1295
3.7.10.1 Sweep/Control 1295
Sweep/Measure 1295
WLAN Mode User's &Programmer's Reference 35