Table Of Contents
9.3 SCPI Operation and Results Query 2567
9.3.1 Mode Control 2567
9.3.2 Measurement Control 2567
9.3.2.1 CONFigure 2568
9.3.2.2 INITiate 2569
9.3.2.3 FETCh 2569
9.3.2.4 READ 2570
9.3.2.5 MEASure 2571
9.3.3 Trace Formatting Commands 2572
9.3.3.1 Clear Trace (Remote Command Only) 2572
9.3.3.2 Send/Query Trace Data (Remote Command Only) 2573
9.3.3.3 Format Data: Numeric Data (Remote Command Only) 2575
9.3.3.4 Format Data: Byte Order (Remote Command Only) 2576
9.3.3.5 Calculate/Compress Trace Data Query (Remote Command
Only) 2576
9.3.3.6 Calculate Peaks of Trace Data (Remote Command Only) 2582
9.3.3.7 Smooth Trace Data (Remote Command Only) 2584
9.3.3.8 Number of Points for Smoothing (Remote Command Only) 2585
9.3.3.9 Mean Trace Data (Remote Command Only) 2586
9.4 Status Register System & STATus Subsystem 2587
9.4.1 Status Register System Diagram 2587
9.4.2 Status Register Hierarchy 2589
9.4.3 Status Register SCPI Commands 2591
9.4.4 How to Use Status Registers 2592
9.4.4.1 Polling Method 2592
Monitoring Options 2593
9.4.4.2 Service Request (SRQ) Method 2593
Using the Service Request (SRQ) Method 2593
9.4.5 Status Register Bit Parameters 2595
9.4.6 Status Subsystem Registers and Commands 2596
9.4.6.1 Status Byte Register 2596
Service Request Enable Register 2599
Preset the Status Byte 2599
9.4.6.2 Standard Event Status Register 2600
Standard Event Status Enable Register 2601
78 WLAN Mode User's &Programmer's Reference
To Next Page
Loading...
