7. MODIFICATION OF THE MEASUREMENT CONDITIONS AND EVALUATING CONDITIONS
In-Cutoff Setup screen
7 Touch [Range set].
¾ The part between rulers 1 and 2 of the evaluation profile turns
red.
TIP
• To select multiple ranges, repeat steps 3 to 7 above.
• To change the range, touch the red part. When the
ruler is displayed, repeat steps 4 to 7 above.
• To cancel the selected range, touch
[Cancel All].
• To cancel a part of the selected range, touch the red
part of the waveform, and then, touch
[Cancel
Part] while the ruler is displayed.
In-Cutoff Setup screen
8 Touch [Close].
¾ “In-Cutoff” is displayed for “Del. Wave” on the Evaluating
Condition Menu screen.
Home screen
¾ When [RE-CAL.] is pressed, “C” is displayed at the
beginning of the calculated results.
■ Operating procedure (By out-cutoff) (Refer to
7.2 “■ Accessing the Evaluating Condition Menu screen”)
Home screen to Main Menu ⇒ ⇒
Evaluating Condition Menu screen
1 Touch on the Evaluating Condition Menu screen.
No. 99MBB765A
7-33
To Next Page
Loading...
