Evaluating Condition Menu screen
2 Touch , then touch .
Desired Tilt Setup screen
3 Set a desired item to use.
NOTE
• The specified range of the first half (defined by P1 and
P2) and that of the latter half (defined by P3 and P4)
must meet the following relationship:
P1 <P2 ≦ P3 < P4
• When the two ends are set, [Fast tilt] and [Last tilt]
cannot be selected.
Desired Tilt Setup screen
4 Set ON/OFF for and touch as necessary.
The position of which tilt compensation is specified usually comes
to the vertical center of the screen. When centering is set to ON,
the waveform center comes to the center of the screen.
Evaluating Condition Menu screen
¾ The set desired profile compensation is displayed on the
Evaluating Condition Menu screen.
No. 99MBB765A
7-42
To Next Page
Loading...
