16. DISPLAYING AND ANALYZING THE EVALUATION PROFILES AND GRAPHS
No. 99MBB765A
■ Details of Analyze Convex Area screen
The result of the convex area parameter is displayed at the bottom right of the Analysis
Graph screen.
TIP
• The ruler 1 (slice level) is displayed in blue, and the ruler 2 (peak height level) is
displayed in red.
• At the first display of the Analyze Convex Area screen after measurement, the ruler is
displayed on the mean line.
• To perform the convex area analysis under the Evaluating Conditions B, select the
evaluation profile by touching
[Switch Profile] on the Analyze Area screen.
• In case of entering the numerical values on the Analyze Convex Step Area screen,
make a setting so that slice level ≦ peak height level.
Convex area parameter setting
mode
switching
height level and slice
level
values
To Next Page
Loading...
