Mitutoyo SURFTEST SJ-410 - Page 434

No. 99MBB765A
16-32
■ Specifying by touching the evaluation profile (Refer to 16.1 "■ Accessing the Analyze Waveform screen".)
Home screen ⇒ [Evaluation Profile] ⇒ [Analyze Waveform]
Analyze Waveform screen
1
Touch .
NOTE
• When R-Motif or W-Motif is selected for a profile motif,
the step area cannot be analyzed.
Analyze Step Area screen
2
Touch [Convex Area].
Analyze Step Area screen
 The rulers are displayed on the Analyze Step Area screen.
The blue one is Ruler 1, the red one is Ruler 2.
When the X-coordinate is specified for the first time, ruler 1 is
selected.
(blue) is displayed on the selected ruler.
Analyze Step Area screen
3
Touch a place to set the ruler 1.
To adjust the ruler position, touch
/
.
Analyze Step Area screen
4
Touch
[Switch Ruler].
 The ruler 2 is selected and
(red) is displayed above.