■ Attaching the automatic positioning unit
NOTE
• Make sure to use the supplied screws.
• When attaching the simple column stand, exercise care so as not to drop the drive unit
or unit to prevent damage.
1 Loosen the 3 mounting screws to remove the mount board of the simple column
stand.
Simple column stand
2 Attach the automatic positioning unit to the simple column stand using the 3
mounting screws.
Mount board
Mounting screws (M4 x 8)
Mounting screws (M4 x 8)
Automatic positioning unit
Simple column stand
3 Attach the drive unit mount board to the rear of the drive/detector unit using the 2
mount board securing screws.
Drive unit mount board
Mounting screws (M4 x 8)
Drive/detector unit
No. 99MBB765A
19-4
To Next Page
Loading...
