Rohde & Schwarz RTP Series - Page 1695

Remote control commands
R&S
®
RTP
1695User Manual 1337.9952.02 ─ 12
TRIGger<m>:MILStd:ERRor:MANChester <ManCodingError>
Triggers on an error of the manchester coding if TRIGger<m>:MILStd:TYPE is set to
ERRor.
Parameters:
<ManCodingError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:PARity <ParityError>
Triggers on even parity if TRIGger<m>:MILStd:TYPE is set to ERRor.
Parameters:
<ParityError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:SYNC
<SyncError>
Triggers on an error of the synchronization if TRIGger<m>:MILStd:TYPE is set to
ERRor.
Parameters:
<SyncError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:MAXResponse:BITS <MaxResponseTime>
Sets the value for the maximum response time to be triggered on if TRIGger<m>:
MILStd:TYPE is set to ERRor
Enable the error trigger on maximum response time with TRIGger<m>:MILStd:
MAXResponse:SELect.
Parameters:
<MaxResponseTime> Range: 2E-6 to 262E-6
Increment: 100E-9
*RST: 14E-6
Default unit: s
TRIGger<m>:MILStd:MAXResponse:SELect <MaxRespSel>
Enables the trigger on exceeding the maximum response time if TRIGger<m>:
MILStd:TYPE is set to ERRor. You can set the maximum time with: TRIGger<m>:
MILStd:MAXResponse:BITS.
Parameters:
<MaxRespSel> ON | OFF
*RST: ON
Protocols