Rohde & Schwarz RTP Series - Page 1849

Remote control commands
R&S
®
RTP
1849User Manual 1337.9952.02 ─ 12
TRIGger<m>:DPHY:WCOunt:CONDition........................................................................1854
TRIGger<m>:DPHY:WCOunt:MAX................................................................................ 1854
TRIGger<m>:DPHY:WCOunt:MIN................................................................................. 1855
TRIGger<m>:DPHY:TYPE <Type>
Sets the type of frame to be triggered on.
Parameters:
<Type> HS_SOP | HS_EOP | HS_PH | HS_DATA | LP_ESC |
LP_TURN | LP_HSRQ
HS_SOP
High speed start of packet
HS_EOP
High speed end of packet
HS_PH
High speed packet header
HS_DATA
High speed data
LP_ESC
Low power escape mode frame
LP_TURN
Low power lane turnaround
LP_HSRQ
Low power high speed request
*RST:
HS_SOP
TRIGger<m>:DPHY:DATA:CONDition <Format>
Set the condition for the data value. You can define an exact value or a value range.
Parameters:
<Format> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:DPHY:DATA:
MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:DPHY:DATA:MIN and
TRIGger<m>:DPHY:DATA:MAX.
*RST:
EQUal
Protocols