Measurements
R&S
®
RTP
327User Manual 1337.9952.02 ─ 12
Cu1, Cu2, Cu3, Cu4
The settings for each cursor measurement (or cursor set) are configured on separate
tabs. For each cursor set, a horizontal pair of cursors, a vertical pair of cursors, or both
can be displayed.
Coupling (2 follows 1)
Couple the horizontal and vertical cursor lines so that the distance between the two
lines remains the same if one cursor is moved.
Remote command:
CURSor<m>:YCOupling on page 1355
CURSor<m>:XCOupling on page 1354
Show in all diagrams
Shows the enabled cursor measurements in all active diagrams of the same (time/
spectrum) domain.
Remote command:
CURSor<m>:SIAD on page 1356
Show label
Shows the cursor labels in the diagram.
Remote command:
CURSor<m>:LABel on page 1356
Cursor measurements
To Next Page
Loading...
