EasyManua.ls Logo

Rohde & Schwarz RTP Series - Page 824

Rohde & Schwarz RTP Series
2403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protocol analysis
R&S
®
RTP
824User Manual 1337.9952.02 ─ 12
"Min"
Specifies an address, or sets the start value of an address range.
"Max"
Sets the end value of an address range if "Condition" (SEARch:
TRIGger:USB:ACONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:WADD on page 2036
SEARch:TRIGger:USB:ACONdition on page 2025
SEARch:TRIGger:USB:AMIN on page 2026
SEARch:TRIGger:USB:AMAX on page 2026
End Point check
Enables the search for an endpoint that meets specific conditions.
"Condition"
Defining a specific endpoint or an endpoint range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an endpoint, or sets the start value of an endpoint range.
"Max"
Sets the end value of an endpoint range if "Condition" (SEARch:
TRIGger:USB:ECONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:WEND on page 2037
SEARch:TRIGger:USB:ECONdition on page 2028
SEARch:TRIGger:USB:EMIN on page 2029
SEARch:TRIGger:USB:EMAX on page 2029
Frame number check
Enables the search for a frame number that meets specific conditions.
"Condition"
Defining a specific frame number or a frame number range requires
to set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a frame number, or sets the start value of a frame number
range.
"Max"
Sets the end value of a frame number range if "Condition" (SEARch:
TRIGger:USB:FCONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:WFRN on page 2037
SEARch:TRIGger:USB:FCONdition on page 2029
SEARch:TRIGger:USB:FMIN on page 2029
SEARch:TRIGger:USB:FMAX on page 2030
Payload check
Enables the search for a payload data pattern that meets specific conditions.
"Condition"
Sets the operator "any" or "equal" that allows to search for payload
data at any position or at a specified position.
USB (option R&S RTP-K60)

Table of Contents

Other manuals for Rohde & Schwarz RTP Series

Related product manuals