Protocol analysis
R&S
®
RTP
885User Manual 1337.9952.02 ─ 12
TLP ← TLP (Transaction layer)
Triggers on a transaction type.
"Any type"
Triggers on any transaction type.
"Mem"
Triggers on memory transaction type used for data transfers to mem-
ory-mapped locations.
"IO"
Triggers on I/O transaction type used for data transfers to I/O-map-
ped locations.
"Cfg"
Triggers on configuration transaction type used to set up the device
functions.
"Msg"
Triggers on message transaction type used for transmitting diverse
messages.
"Cpl"
Triggers on completion without data.
"FetchAdd"
Triggers on fetch and add atomic op request.
"Swap"
Triggers on unconditional swap atomic op request.
"CAS"
Triggers on compare and swap atomic op request transaction type.
Remote command:
TRIGger<m>:PCIE:TLP:TYPE on page 2139
Sequence Number ← TLP (Transaction layer)
Triggers on a sequence number, which indicates if any TLPs have been lost.
Remote command:
TRIGger<m>:PCIE:TLP:SNUM on page 2139
TC ← TLP (Transaction layer)
Triggers on a traffic class which is mapped on a specific virtual channel. The TC label
is transmitted unmodified through the fabric.
Remote command:
TRIGger<m>:PCIE:TLP:TCHN on page 2139
Ordering ← TLP (Transaction layer)
Triggers on an ordering. The ordering can be relaxed or strong.
Remote command:
TRIGger<m>:PCIE:TLP:ORDE on page 2138
PCIe (option R&S
RTP-K72/K73)
To Next Page
Loading...
