Rohde & Schwarz RTP Series - Page 886

Protocol analysis
R&S
®
RTP
886User Manual 1337.9952.02 ─ 12
Snoop ← TLP (Transaction layer)
Triggers on a snoop state.
Remote command:
TRIGger<m>:PCIE:TLP:SNOO on page 2139
Requester ID ← TLP (Transaction layer)
Triggers on a requester ID, consisting of the requester's bus number, device number,
and function number.
Remote command:
TRIGger<m>:PCIE:TLP:REID on page 2139
Device ID ← TLP (Transaction layer)
Triggers on a device ID, a field that can be assigned a value by the vendor for classify-
ing root complex register blocks (RCRB). The Device ID is only valid for Configuration
transaction. It is composed of 8-bit us number, 5-bit device number and a 3-bit function
number.
Remote command:
TRIGger<m>:PCIE:TLP:DEID on page 2138
Read/Write ← TLP (Transaction layer)
Triggers on a read and/ or write state.
Remote command:
TRIGger<m>:PCIE:TLP:MERW on page 2138
Address Type ← TLP (Transaction layer)
Triggers on an address type. The address type can be 32 bit or 64 bit.
Remote command:
TRIGger<m>:PCIE:TLP:ADRT on page 2137
Type ← TLP (Transaction layer)
Triggers on a configuration type.
Remote command:
TRIGger<m>:PCIE:TLP:CFGT on page 2137
Routing ← TLP (Transaction layer)
Triggers on a selected message routing type.
Remote command:
TRIGger<m>:PCIE:TLP:MSGR on page 2138
Message Code ← TLP (Transaction layer)
Triggers on a specific message code.
Remote command:
TRIGger<m>:PCIE:TLP:MSGC on page 2138
Status ← TLP (Transaction layer)
Triggers on a completion status.
PCIe (option R&S
RTP-K72/K73)