Rohde & Schwarz SMBV100B - Arb General Settings

Configuring the Internal Baseband Source
R&S
®
SMBV100B
151User Manual 1178.4460.02 ─ 03
3.6.3.1 ARB General Settings
Access:
► Select "Baseband > ARB".
This tab provides access to the default ARB settings, selecting a waveform file and
enabling the ARB generator.
Further settings depend on selected "System Configuration" and waveform type:
●
If a single segment waveform is used, the tab provides also settings for configuring
the test signal and access to the settings for calculating a multi-segment or a multi-
carrier waveform.
●
If a multi-segment waveform is loaded, the tab expands and displays the dedicated
section "Multi Segment Waveform Options".
This section comprises the settings necessary to configure the segment to be out-
put and adjust the trigger for the switch between the segments of the multi-seg-
ment waveform. The parameters displayed depend on the selected trigger source.
The provided parameters are identical with the parameters in the section "Next
Segment Trigger In" in the "Trigger" tab; for information see Chapter 3.7.3.5, "Next
Segment Trigger In Settings", on page 212.
Settings:
State............................................................................................................................152
Set To Default..............................................................................................................152
Load Waveform/File.................................................................................................... 152
Waveform Info.............................................................................................................153
Clock Frequency......................................................................................................... 153
Create Multi Segment................................................................................................. 153
Create Multi Carrier.....................................................................................................154
Using the Arbitrary Waveform Generator (ARB)