Rohde & Schwarz SMBV100B - Global Connectors Settings

General Instrument Functions
R&S
®
SMBV100B
520User Manual 1178.4460.02 ─ 03
3. Use the built-in Show Connector function to display the physical location of the
selected connector.
The eye icon in the tab header indicates the panel (front, rear or both) the
selected connector is located at.
Settings:
Signal.......................................................................................................................... 520
Connector....................................................................................................................520
Show Connector..........................................................................................................520
Signal
Opens the dialog with the corresponding settings.
Connector
Displays the assigned connector.
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
10.2.5 Global Connectors Settings
Access:
1. Perform one of the following:
● In the "Block Diagram", select the T/M/C status LEDs to access the "Trigger
Marker Clock" dialog and:
– Select a User connector or
– Select "Global Connector Settings".
Configuring the Global Connectors