General Instrument Functions
R&S
®
SMBV100B
518User Manual 1178.4460.02 ─ 03
2. Use the built-in Show Connector function to display the physical location of the
selected connector.
A blinking LED on the rear panel indicates the selected connector, too.
The eye icon in the tab header indicates the panel (front, rear or both) the
selected connector is located at.
10.2.3.1 Overview Table
Logical Signal
Displays the logical signal, as configured in the "Trigger In", "Marker" or "Clock" tab of
the corresponding digital standard, see for example Chapter 3.4.2.1, "Trigger Settings",
on page 110.
Connector
Displays the assigned connector.
Configuring the Global Connectors
To Next Page
Loading...
