Rohde & Schwarz SMBV100B - Source > External Settings

Configuring the RF Signal
R&S
®
SMBV100B
368User Manual 1178.4460.02 ─ 03
Trapezoid Rise / Fall
Sets the time required for the trapezoid signal to change from low level to high level,
and vice versa.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:RISE on page 846
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL on page 845
Trapezoid High
Sets how long the trapezoid signal is at high level.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:HIGH on page 845
Source > External Settings
Access:
► Select "RF" > "Analog Modulation" > "Modulation Source... > External".
The "External" settings section contains all parameters required to configure the
signal of an externally supplied LF signal.
Settings
Coupling (AC/DC)....................................................................................................... 368
Impedance.................................................................................................................. 369
Bandwidth................................................................................................................... 369
Show Connector..........................................................................................................369
Coupling (AC/DC)
Selects the coupling mode (AC or DC) for the external signal.
"AC"
Disconnects the DC voltage component and uses only the AC com-
ponent of the modulation signal.
"DC"
Uses the modulation signal with both components, AC and DC.
Analog Modulations