Rohde & Schwarz SMBV100B - LF Sweep Settings

Remote Control Commands
R&S
®
SMBV100B
847User Manual 1178.4460.02 ─ 03
Example: See Example "Configuring the LF generator" on page 838.
Manual operation: See "Triangle Rise" on page 367
12.16.10.2 LF Sweep Settings
With the commands described in this section, you can configure the sweep of the LF
signal.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl................................................... 847
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute................................................847
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE....................................................848
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts...................................................848
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace............................................... 848
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?..............................................849
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe...................................................849
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing................................................ 849
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic..................................849
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]........................................ 850
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for each frequency step of the sweep.
Parameters:
<Dwell> float
Range: 0.001 to 100
Increment: 100E-6
*RST: 0.01
Default unit: s
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Dwell Time " on page 330
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute
Immediately starts an LF sweep.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE determines which sweep
is executed, e.g. SOURce:LFOutput:SWEep:FREQuency:MODE STEP.
Example:
See Example "Setup an LF sweep" on page 837.
Usage: Event
Manual operation: See " Execute Single Sweep " on page 331
SOURce Subsystem