Rohde & Schwarz SMBV100B - Selftest Connections Settings

Maintenance
R&S
®
SMBV100B
935User Manual 1178.4460.02 ─ 03
Remote command:
:CALibration:ALL[:MEASure]? on page 629
Last Full Adjustment
Displays the date of the last fully performed adjustment.
Remote command:
:CALibration<hw>:ALL:DATE? on page 630
Time Since Last Full Adjustment
Displays the elapsed time since the last full adjustment.
Remote command:
:CALibration<hw>:ALL:TIME? on page 631
Temperature Offset Since Last Full Adjustment
Displays the temperature difference, comparing the temperature at the beginning of the
last adjustment to the temperature at the beginning of the present adjustment.
If the temperature deviates more than ± 5 K, the background of the parameter turns
yellow.
Remote command:
:CALibration<hw>:ALL:TEMP? on page 630
Information
Displays information to the current adjustment state.
Remote command:
:CALibration<hw>:ALL:INFormation? on page 630
13.3.4 Selftest Connections Settings
Access:
► Select "System Config > Setup > Maintenance > Selftest > Connections".
Performing Maintenance Tasks