File and Data Management
R&S
®
SMBV100B
476User Manual 1178.4460.02 ─ 03
► To reset an individual parameter: Open its context-sensitive menu and select "Pre-
set this parameter...".
●
"Factory Preset"
A factory preset is the most profound preset function that resets almost all instru-
ment settings, including reference oscillator, network and remote access settings.
Retained are the following settings:
– Security, password, and settings protected by these passwords
– User-defined data, like setups or data lists
– Settings that relate to an integration of the instrument in a measurement setup.
► To restore the factory defaults, select System Config > Setup > Settings > Factory
Preset.
Note: Perform a "Factory Preset" only if it is necessary. After a "Factory Preset",
the network connection to the instrument no longer exists.
Presetting the instrument to a user-defined instrument state
The reset functions set the parameters and operating modes to default values prede-
fined by the factory. Alternatively to these default settings, you can:
●
Define user-specific recall settings to be restored after a preset
(see Chapter 9.2.3, "How to Recall User Settings Automatically after Preset",
on page 478)
●
Store and reload user-defined instrument states
(see Chapter 9.4.2, "How to Save and Recall Instrument Settings", on page 485)
Mark / Do not mark parameters changed from preset
To survey the current state of the settings concerning default values, the
R&S SMBV100B offers a feature that visually identifies deviations from the default val-
ues.
For more information, see Chapter 9.2.2, "How to Identify Parameters Which Are Not in
a Preset State", on page 477.
9.2.1 Preset, Set to Default and Factory Preset Settings
Preset..........................................................................................................................476
Set To Default..............................................................................................................477
Preset this Parameter................................................................................................. 477
Execute Factory Preset...............................................................................................477
Preset
Resets all parameters and switching states, and closes all opened dialogs.
Note: External instruments connected to the R&S SMBV100B are also preset.
Restoring the (Default) Instrument Configuration
To Next Page
Loading...
