Rohde & Schwarz SMBV100B - Carrier Graph

Configuring the Internal Baseband Source
R&S
®
SMBV100B
247User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe on page 786
[:SOURce<hw>]:BB:MCCW:CARRier:STATe on page 786
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer on page 788
[:SOURce<hw>]:BB:MCCW:CARRier:POWer on page 788
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe on page 787
[:SOURce<hw>]:BB:MCCW:CARRier:PHASe on page 787
3.9.3.3 Carrier Graph
Access:
► Select "Baseband > Multi-Carrier CW > Carrier Graph".
The "Carrier Graph" tab is a graphical representation of the current carrier configura-
tion.
The carriers are on the X-axis and the colored bars represent those carriers which are
in the active state. Power is on the Y-axis, and the height of the bars corresponds to
the chosen power of each individual carrier.
3.9.3.4 Trigger, Marker and Clock Setting
These tabs provide standard settings.
For detailed description, see:
●
Chapter 3.4.2.1, "Trigger Settings", on page 110
●
Chapter 3.4.2.2, "Marker Settings", on page 113
●
Chapter 3.4.2.3, "Clock Settings", on page 115
●
Chapter 3.4.2.4, "Global Connector Settings", on page 115
Generating Multi-Carrier Continuous Wave Signal