Remote Control Commands
R&S
®
SMBV100B
850User Manual 1178.4460.02 ─ 03
Parameters:
<Logarithmic> float
The unit is mandatory
Range: 0.01 to 100
Increment: 0.01
*RST: 1
Default unit: PCT
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Step Linear/Step Logarithmic " on page 333
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]
<Linear>
Sets the step width for the linear sweep.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode",
on page 320
Parameters:
<Linear> float
Range: 0.1 to STOP-STARt
Increment: 0.1
*RST: 1000
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Step Linear/Step Logarithmic " on page 333
12.16.11 SOURce:LIST Subsystem
The SOURce:LIST subsystem contains all commands for defining lists and for han-
dling of list files.
List files have the predefined file extension *.lsw.
Refer to Chapter 12.6.2, "Accessing Files in the Default or in a Specified Directory",
on page 618 for general information on file handling in the default and in a specific
directory.
●
*RST does not affect data lists.
●
SCPI refers to the individual lists as segments.
Example: Create an RF list and activate the list mode
The following example shows a command sequence to create an RF list and to acti-
vate the list mode. Further hardware settings are not considered.
// Reset the instrument to start from an initial state
// Query the available list files in the default
SOURce Subsystem
To Next Page
Loading...
