File and Data Management
R&S
®
SMBV100B
487User Manual 1178.4460.02 ─ 03
Sources in the Baseband", on page 89). To simulate the signal of one UE for instance,
the instrument modulates and codes the provided data for each channel. It further pro-
cesses the signal as described in the corresponding standard.
Whenever a data list file is enabled as a data source, the instrument provides direct
access to the standard "File Select" function. This function enables you to select, cre-
ate and edit the data list files.
9.5.1 File Select Settings
The "File Select" dialog opens automatically each time you select a data list file as data
source or you select a control list.
To access a loadable data list file
1. Select the "Data List Name" in the individual dialog.
For "Baseband > 3GPP FDD > Base Stations > BS1 > Channel Table > P-CCPCH
> Data = Data List", for example, select "DList Patt = None".
A "File Select" dialog for loading, creating and modifying a file is displayed.
Tip: The name of the dialog is context-sensitive and differs depending on the par-
ticular function this dialog is from. However, the provided functions are similar.
2. To load an existing file:
Navigate through the file system.
Select the file and confirm with "Select".
3. To create a file, for example if there is no data list file specified:
Navigate through the file system.
Select "New" and specify the filename.
A new empty file is created and saved in the selected folder.
4. To edit an existing or newly created file:
Navigate through the file system.
Accessing Files with User Data
To Next Page
Loading...
