Getting Started
R&S
®
SMBV100B
52User Manual 1178.4460.02 ─ 03
● Generating an Unmodulated Carrier.......................................................................52
● Generating a Digitally Modulated Signal.................................................................53
● Triggering the Instrument with an External Signal.................................................. 56
● Enabling and Configuring a Marker Signal..............................................................60
● Verifying the Generated Signal with the Graphics Display......................................61
● Saving and Recalling Settings................................................................................ 64
● Generating an EUTRA/LTE Signal..........................................................................67
2.3.1 Generating an Unmodulated Carrier
We start out by generating a simple unmodulated signal. The R&S SMBV100B in this
example can be a base unit in its minimal configuration (i.e. with installed
R&S SMBVB-B103).
1. On the R&S SMBV100B front panel, press the Preset key to start out in a defined
instrument configuration.
2. Set the frequency:
a) On the "Status Bar", tap the "Frequency" field.
b) On the on-screen keypad, enter 1.955 and press the "GHz" key.
The on-screen keypad closes and the frequency value is displayed.
3. On the "Status Bar", tap the "Level" field and enter the level in the same way.
4. Select "Block Diagram > RF Block > On" to enable the output of the generated
unmodulated signal.
Trying Out the Instrument
To Next Page
Loading...
