Rohde & Schwarz SMBV100B - Source > Noise Generator Settings

Configuring the RF Signal
R&S
®
SMBV100B
369User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:INPut:MODext:COUPling on page 829
Impedance
Sets the impedance for the externally supplied signal.
Remote command:
[:SOURce<hw>]:INPut:MODext:IMPedance<ch> on page 829
Bandwidth
Displays the maximum bandwidth of the external LF signal.
Remote command:
[:SOURce]:LFOutput<ch>:BANDwidth? on page 840
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
Source > Noise Generator Settings
Access:
► Select "RF" > "Analog Modulation" > "Modulation Source... > Noise Generator".
The "Noise Generator" settings contain all parameters to configure the signal of the
internal noise generator.
Settings
Distribution.................................................................................................................. 369
Bandwidth................................................................................................................... 370
Distribution
Selects the distribution of the noise power density.
Analog Modulations