Rohde & Schwarz SMBV100B - Source:iq:output Subsystem

Remote Control Commands
R&S
®
SMBV100B
832User Manual 1178.4460.02 ─ 03
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
IQ:SWAP ON
swaps the I and Q channel.
Manual operation: See "I/Q Swap" on page 279
[:SOURce<hw>]:IQ:WBSTate <WbState>
Activates wideband mode.
This setting automatically optimizes the settings for wideband modulation signals
(>5 MHz, State ON).
Parameters:
<WbState> 0 | 1 | OFF | ON
*RST: 0
Example:
IQ:WBST ON
switches to wideband mode.
Manual operation: See "I/Q Wideband" on page 280
12.16.9 SOURce:IQ:OUTPut Subsystem
The SOURce:IQ:OUTPut subsystem contains the commands for configuring the ana-
log and digital I/Q output signals.
For information about the required options, see:
●
Chapter 8.7, "I/Q Analog Output Settings", on page 464
For information on the connector and interfaces the analog and digital I/Q signals are
output at, see:
Chapter 8.4.1.4, "Overview of the Input and Output Signals and Interfaces",
on page 436.
12.16.9.1 SOURce:IQ:OUTPut:ANALog Commands
This section describes the commands of the output of an analog I/Q signal.
SOURce Subsystem