Rohde & Schwarz SMBV100B - LF Signal Output Settings

Configuring the RF Signal
R&S
®
SMBV100B
370User Manual 1178.4460.02 ─ 03
"Gauss"
Generates the noise power according to a Gaussian distribution.
"Equal"
Generates an evenly distributed noise.
Remote command:
[:SOURce<hw>]:NOISe:DISTribution on page 864
Bandwidth
Sets the noise bandwidth as distinct value.
You can set the bandwidth between 100 kHz and 10 MHz in 100 KHz steps.
Remote command:
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth on page 863
[:SOURce<hw>]:NOISe:BWIDth:STATe on page 863
6.11.4.7 LF Signal Output Settings
Access:
► Select "RF" > "Analog Modulation" > "LF Output".
In the "LF Output" tab, you can configure the signal at the LF outputs, determine
the output voltage or add a DC offset. Activate both paths to output the sum signal
of the two sources.
See also Chapter 6.11.4.8, "Overview", on page 372.
Settings:
State............................................................................................................................371
Source.........................................................................................................................371
Output Voltage............................................................................................................ 371
DC-Offset.................................................................................................................... 371
Show Connector..........................................................................................................371
Source Impedance......................................................................................................371
Analog Modulations