Rohde & Schwarz SMBV100B - Protection Level Settings

General Instrument Functions
R&S
®
SMBV100B
537User Manual 1178.4460.02 ─ 03
See also Chapter 10.5.4, "Password Management", on page 545.
●
LAN services secure controlled network access
You can individually lock and unlock the supported LAN interface services, see
Chapter 10.5.3, "Configuring LAN Services", on page 543.
Remote control via LAN interface requires that the interface is activated, but you
can enable the required services specifically.
●
User interface prevents front panel operation and/or reading the display.
For more information, see the document R&S SMBV100B Instrument Security Proce-
dures.
10.5.1 Protection Level Settings
Access:
► Select "System Config > Setup > Security > Protection".
The "Protection" dialog provides access to the unlocking of different protection lev-
els.
Several functions in the instrument are password-protected to prevent for example
accidental changes, "Protection" on page 536.
The remote commands required to unlock a protected stage are described in Chap-
ter 12.17, "SYSTem Subsystem", on page 889.
Protection Level/Password
Unlocks the selected level of protection, if you enter the correct password.
The default protection level 1 password is 123456.
To lock the protection level again, clear the checkbox.
Remote command:
:SYSTem:PROTect<ch>[:STATe] on page 896
Using the Security Settings