Rohde & Schwarz SMBV100B - Connector Settings

Remote Control Commands
R&S
®
SMBV100B
677User Manual 1178.4460.02 ─ 03
● SOURce:POWer Subsystem................................................................................ 867
● SOURce:ROSCillator Subsystem......................................................................... 876
● SOURce:SWEep Subsystem................................................................................881
12.16.1 Connector Settings
This section summarizes the commands of the OUTPut and INPut subsystems, nec-
essary to configure the connectors settings. Listed are the commands for configuring
the output signals and the inputs for trigger, data, and control signals.
The ...:USER<ch>:... commands determine the global trigger threshold and input
impedance values, that affect all trigger and control signal inputs. The connector set-
tings concern to all digital modulations, the generation of waveforms or multi carrier
signals, and all digital standards.
Refer to Chapter 12.16.7, "SOURce:INPut Subsystem", on page 829 for description
of the commands for configuring the inputs for external modulation signals.
Required options
See Chapter 10.2, "Configuring the Global Connectors", on page 515.
Example: Global connectors settings configuration
SOURce1:INPut:USER1:DIRection INP
SOURce1:INPut:USER1:SIGNal TRIG1
SOURce1:INPut:USER3:DIRection INP
SOURce1:INPut:USER3:SIGNal NSEGM1
SOURce1:INPut:USER5:DIRection INP
SOURce1:INPut:USER5:SIGNal TRIG2
SOURce1:INPut:USER:TRIGger:LEVel 1.5
SOURce1:INPut:USER:PULM:LEVel 2
// the signal threshold at USER 1-2 is 1.5 V
// this applies to all input signal, i.e. TRIG1 and NSEGM1
// the signal threshold at USER 3-5 is 2 V
// this applies to all input signal, i.e. TRIG2
SOURce1:INPut:USER1:TRIGger:IMPedance G1K
SOURce1:INPut:USER1:TRIGger:SLOPe POS
SOURce1:INPut:USER2:DIRection OUTP
OUTPut1:USER2:SIGNal MARKA2
[:SOURce]:INPut:USER<ch>:DIRection............................................................................678
:OUTPut:USER<ch>:DIRection....................................................................................... 678
[:SOURce]:INPut:USER<ch>:SIGNal............................................................................... 678
:OUTPut:USER<ch>:SIGNal........................................................................................... 679
:OUTPut:USER<ch>:TRIGger[:IMMediate]....................................................................... 679
[:SOURce]:INPut:USER:CLOCk:LEVel............................................................................. 680
[:SOURce]:INPut:USER:TRIGger:LEVel........................................................................... 680
SOURce Subsystem