Configuring the RF Signal
R&S
®
SMBV100B
324User Manual 1178.4460.02 ─ 03
Configuration and operation of list mode signals
The parameters configuring the RF signal are defined in a list (table) and stored in a
file.
Creating and handling lists
List files can be created in the following ways:
●
Internally
Use the build-in table editor with columns for the frequency-level values pairs and
the dwell time.
Define the values manually (row by row) or automatically, based on value range
and step size.
(See Chapter 6.10.7, "List Editor", on page 341)
Lists are saved as files with user-definable filename and the predefined file exten-
sion *.lsw. To load a saved file, use the "File Manager".
(See Chapter 9.8, "Using the File Manager", on page 491)
●
Lists can be exported, too. For example, to exchange configuration between instru-
ments or to modify the file content with an external program and reload them again.
●
Externally
Create a list file as a CSV file with Microsoft Excel, with a Notepad or a similar tool
and save it with the predefined extension. Transfer the file to and load it into the
instrument.
Dwell time mode
You can choose whether you want to use different dwell times or a fixed value for all
steps in the list mode:
●
"From List"
This mode uses the values from the data table.
See Edit List Mode Data
●
"Global"
This mode processes the list with a fixed time interval you can set with Global
Dwell Time.
List processing mode
See:
●
"Live list processing mode" on page 326
6.10.4 Significant Parameters and Functions
This section provides some basic parameters, settings and functions that affect the
operating modes CW, list and sweep, that means at all frequency and level transitions
of the RF signal.
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
