Rohde & Schwarz SMBV100B - Page 345

Configuring the RF Signal
R&S
®
SMBV100B
343User Manual 1178.4460.02 ─ 03
All columns in a row must contain values. Cells with missing values are therefore filled
automatically, using the value of the previous row.
If you use global dwell time in list mode, consider also that the instrument uses the
value set with Global Dwell Time for all list steps and not the values from the list.
Since the table and navigation functions can be assumed to be known, the following
description contains a brief overview, shown by the example of the "List Data Editor". If
a function relates to a particular dialog, it is explicitly stated.
Settings
Edit List Mode Data.....................................................................................................343
Data handling keys .....................................................................................................343
└ Go To............................................................................................................ 343
└ Edit................................................................................................................344
└ Fill with Sensor..............................................................................................344
└ Save As/Save............................................................................................... 344
Fill... ............................................................................................................................344
Edit List Mode Data
Table with values for list or user correction processing.
Note: Once you enter a value, the editor automatically adds preset values in the other
columns. This functionality protects against data loss, otherwise incomplete rows will
be lost when saving. You can simply override these values.
"Frequency /Hz"
Sets the frequency values.
Remote command:
[:SOURce<hw>]:LIST:FREQuency on page 855
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 813
"Power /dBm"
Sets the level values.
Remote command:
[:SOURce<hw>]:LIST:POWer on page 856
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 813
"Dwell /s"
In list mode, sets the dwell time values.
Remote command:
[:SOURce<hw>]:LIST:DWELl:LIST on page 854
Data handling keys
Standard functions for file and data handling.
Go To ← Data handling keys
Selects a row for editing.
Varying the RF Signal in List or Sweep Mode