Rohde & Schwarz SMBV100B - Graphical Signal Display Settings

Monitoring Signal Characteristics
R&S
®
SMBV100B
418User Manual 1178.4460.02 ─ 03
Remove
Removes the selected graphical signal display from the taskbar/graphical diagrams
table.
Remote command:
[:SOURce]:BB:GRAPhics:CLOSe on page 808.
Note, that this command closes all graphical signal displays.
7.1.4 Graphical Signal Display Settings
Access:
1. Select "Taskbar > System Config > Graphics > Add".
2. Double click the thumbnail in the taskbar.
Figure 7-10: Graphical signal display of a power spectrum with markers
This section focuses on the functions of the enlarged graphical signal displays.
Settings:
Configure.....................................................................................................................418
Stop / Run................................................................................................................... 419
Zoom Out.................................................................................................................... 419
Reference Curves....................................................................................................... 419
Display Units............................................................................................................... 419
Show / Hide marker.....................................................................................................419
Reference Curve.........................................................................................................419
Configure
Opens the "Graphics Configuration" dialog, see Chapter 7.1.3, "Graphics Configuration
Settings", on page 414.
Displaying Baseband Signal Characteristics in Real-Time