Remote Control Commands
R&S
®
SMBV100B
749User Manual 1178.4460.02 ─ 03
The resulting clock rate must not exceed the maximum ARB clock rate (see data
sheet).
The maximum value is automatically restricted by reference to the set frequency and
has to fulfill the rule Frequency * Samples <= ARB clock rate.
Parameters:
<Samples> integer
Range: 4 to 1000
*RST: 100
Example: see Example "Creating test signals" on page 737
Manual operation: See "Samples per Period" on page 155
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed <Filename>
Generates a signal and saves it to a waveform file.
Setting parameters:
<Filename> string
Example: See Example "Creating test signals" on page 737
Usage: Setting only
Manual operation: See "Generate Signal File" on page 156
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
Example:
see Example "Creating test signals" on page 737
Usage: Event
Manual operation: See "Generate Signal RAM" on page 156
Waveform Commands
The following rule applies for all commands described in this section.
By default, the waveform files are saved in the default directory of the instrument, that
is the /var/user/ directory or the directory specified with the command :MMEMory:
CDIRectory. To access the waveform files in this default directory, only the file name
is required, without the path and the file extension (*.wv).
However, to access waveform files located in a directory different to the default one,
the complete file path and file name are required.
SOURce Subsystem
To Next Page
Loading...
