Configuring the Internal Baseband Source
R&S
®
SMBV100B
113User Manual 1178.4460.02 ─ 03
See also "Specifying delay and inhibit values in time units" on page 102.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:DELay:UNIT on page 727
[:SOURce<hw>]:BB:ARBitrary:TRIGger:DELay:UNIT on page 775
(Specified) External Delay/(Specified) Trigger Delay
The name of the parameter and the units the delay is expressed in, changes depend-
ing on the parameter (External) Delay Unit.
Delays the trigger event provided by:
●
The external trigger source
●
Other instrument in master-slave mode
Use the settings to:
●
Synchronize the instrument with the device under test (DUT) or other external devi-
ces
●
Compensate for signal delay and align the signals in time
For more information, see:
●
"Impact of the Additional Trigger Settings" on page 100
●
"Specifying delay and inhibit values in time units" on page 102
The parameter Actual Trigger Delay/Actual External Delay displays the delay conver-
ted in time.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger[:EXTernal]:DELay on page 727
[:SOURce<hw>]:BB:DM:TRIGger[:EXTernal]:TDELay on page 727
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:DELay on page 775
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:TDELay on page 776
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:DELay on page 792
Actual Trigger Delay/Actual External Delay
Displays the time (in seconds) an external trigger event or a trigger event form the
other path is delayed with.
See also "Specifying delay and inhibit values in time units" on page 102.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger[:EXTernal]:RDELay? on page 728
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:RDELay? on page 776
3.4.2.2 Marker Settings
Access:
► Select "Baseband > Custom Dig Mod > Marker".
This tab provides access to the settings necessary to select and configure the marker
output signal, like the marker mode or marker delay settings.
Common Functions and Settings in the Baseband Domain
To Next Page
Loading...
