Rohde & Schwarz SMBV100B - Page 794

Remote Control Commands
R&S
®
SMBV100B
792User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce <Source>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (INTernal)
●
External trigger signal via one of the User x connectors
– EGT1: External global trigger
– EGC1: External global clock
●
In master-slave mode, the external baseband synchronization signal (BBSY)
●
EXTernal: Setting only
Provided only for backward compatibility with other Rohde & Schwarz signal gener-
ators.
The R&S SMBV100B accepts this value and maps it automatically as follows:
EXTernal = EGT1
Parameters:
<Source> INTernal|EGT1|EGC1|EXTernal|BBSY
*RST: INTernal
Example: See "Programming Examples" on page 779
Manual operation: See "Source" on page 111
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:DELay <Delay>
Specifies the trigger delay.
Parameters:
<Delay> float
Range: 0 to 2147483647
Increment: 0.01
*RST: 0
Default unit: samples
Example: See "Programming Examples" on page 779
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 113
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:INHibit <Inhibit>
Specifies the number of samples by which a restart is inhibited following an external
trigger event.
Parameters:
<Inhibit> integer
Range: 0 to 21.47*clockRate
*RST: 0
Example: See "Programming Examples" on page 779
SOURce Subsystem