Getting Started
R&S
®
SMBV100B
64User Manual 1178.4460.02 ─ 03
This action has no effect on the configured graphics but on the dialog itself.
The block diagram displays the current signal routing. It indicates that frequency
and power offsets are enabled and displays the acquisition points for the real-time
diagrams minimized in the "Taskbar".
See also Chapter 7, "Monitoring Signal Characteristics", on page 407.
2.3.6 Saving and Recalling Settings
To restore the results of our measurements later, we save the instrument settings to a
file.
To save the instrument settings to a file
We assume, a test configuration as described in Chapter 2.3.4, "Enabling and Config-
uring a Marker Signal", on page 60.
1. Press the Save/Rcl key on the front panel.
2. In the "Save/Recall" dialog box, select "Operation Mode > Save".
Tap the "Filename", use the on-screen keyboard, and enter MyTestSignal.
Trying Out the Instrument
To Next Page
Loading...
