Rohde & Schwarz SMBV100B - Multi-Instrument Settings

Multi-Instrument Setups
R&S
®
SMBV100B
429User Manual 1178.4460.02 ─ 03
Additionally, all instruments in the setup have to use the same reference frequency.
You can distribute the internal reference frequency of one of the instruments, regard-
less if master or slave, to all other or supply all instruments from an external reference
frequency source.
8.3.1.1 Multi-Instrument Settings
Access:
► Use one of the following:
● Select "Taskbar > System Config > System Configuration > Multi Instrument"
● Select "Block Diagram > I/Q Stream Mapper > System Configuration > Multi
Instrument"
● On the instrument front panel, press [Setup].
Select "System Configuration > Multi Instrument".
For step-by-step description, see Chapter 8.3.1.2, "How to Connect and Configure
Instruments in Master-Slave Mode", on page 430.
Settings:
State............................................................................................................................429
Multi Instrument Trigger.............................................................................................. 430
Synchronisation State................................................................................................. 430
Global Connector Settings.......................................................................................... 430
State
Activates the configuration.
With "State = Off", the instrument works in a standalone mode.
Remote command:
:SCONfiguration:MULTiinstrument:STATe on page 664
Generating Time-Aligned Baseband Signals