Configuring the Internal Baseband Source
R&S
®
SMBV100B
199User Manual 1178.4460.02 ─ 03
●
The triangle on the top line denotes a trigger event. A filled triangle on the bottom
line denotes a next segment event.
●
A green sine wave (or other shape) over a full period indicates one replay cycle of
a segment. A shorter example signal indicates a replay cycle which was interrup-
ted, e.g. due to a next segment event (compare the two graphics in Table 3-15).
Table 3-15: Trigger examples in the ARB dialog
"Next Segment Mode = Next Segment" "Next Segment Mode = Next Segment Seamless"
3.7.3 Multi-Segment Settings
Access:
1. Select "Baseband > ARB > General > Create Multi Segment".
The "ARB: Multi Segment" dialog enables direct assignment of waveforms to the
multiple segments, adjusting the clock, level, and marker settings of the composed
waveform and selecting the output file.
For description on the provided settings, refer to:
Chapter 3.7.3.1, "Setting for Handling the Multi-Segment Files and Output File Set-
tings", on page 200,
Chapter 3.7.3.2, "Segment Table", on page 202 and
Chapter 3.7.3.3, "Level / Clock / Marker Settings", on page 205
2. Select "ARB: Multi Segment > General" > "Create and Load Output File" to store
and load current multi-segment file.
Generating Multi-Segment Waveform Files
To Next Page
Loading...
