Configuring the RF Signal
R&S
®
SMBV100B
390User Manual 1178.4460.02 ─ 03
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe on page 815
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 814
Used SMBV100B Settings For Measurement
Displays the settings relevant for the measurement.
"Modulation"
Indicates the modulation state
"Amplitude"
Shows the currently set level.
Remote command:
n.a.
6.12.3.4 Import/Export List Files
Access:
1. Select one of the following:
● "RF" > "Sweep/List" > "List mode".
● "RF" > "RF Level" > "User Correction".
2. Select "Import/Export".
Figure 6-20: Im-/Export dialog (example with UCOR settings)
Improving Level Performance
To Next Page
Loading...
