Rohde & Schwarz SMBV100B - Page 816

Remote Control Commands
R&S
®
SMBV100B
814User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency:POINts?
[:SOURce<hw>]:CORRection:CSET:DATA:POWer:POINts?
Queries the number of frequency/level values in the selected table.
Return values:
<Points> integer
Range: 0 to 10000
*RST: 0
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 811 .
Usage: Query only
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
Fills the selected user correction table with the level values measured by the power
sensor for the given frequencies.
To select the used power sensor set the suffix in key word SENSe.
Example:
See Example "Fill user correction data with sensor"
on page 812.
Usage: Event
Manual operation: See " Fill User Correction Data with Sensor" on page 389
[:SOURce<hw>]:CORRection:CSET[:SELect] <Filename>
Selects or creates a file for the user correction data.
If the file with the selected name does not exist, a new file is created.
Parameters:
<Filename> string
Filename or complete file path; file extension can be omitted.
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 811 .
Manual operation: See "UCOR Data" on page 385
[:SOURce<hw>]:CORRection:VALue?
Queries the current value for user correction.
Return values:
<Value> float
Range: -100 to 100
Increment: 0.01
*RST: 0
SOURce Subsystem