Multi-Instrument Setups
R&S
®
SMBV100B
454User Manual 1178.4460.02 ─ 03
Mode
You can send a single command ("Command") or a command sequence ("Sequence")
to the connected instrument.
Command, Send Command
Entry field for the SCPI commands.
You can enter a new command or select a previously sent command from the "His-
tory".
If the remote connection is active, select "Send Command" to execute the command.
File, Sequence, Send Sequence
Accesses the standard "File Select" dialog for loading of user-defined files with exten-
sion *.iec.
The provided navigation possibilities in the dialog are self-explanatory.
When a file is selected, its name and content are displayed, and the first command is
selected. You can send the commands one by one ("Send Command") or send the
entire sequence at once ("Send Sequence").
After a command is sent, the next command form the sequence is selected.
See also:
●
"Initialization Sequence" on page 452
●
Chapter 9.5.1, "File Select Settings", on page 487.
History, Clear History
List of the sent commands.
As long as this history list is not cleared ("Clear History"), you can select a command
from the list and send it again.
Commands Trace, Clear Trace
List of the sent commands and their results, where the results are displayed in blue
color.
To delete the trace, select "Clear Trace".
Show Connector
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select
"Show Connector".
The dialog displays the location of the selected connector.
The "Show Connector" function triggers the instrument to identify the connector on
the rear panel. The LED next to the selected connector blinks.
System Configuration Settings
To Next Page
Loading...
