Network Operation and Remote Control
R&S
®
SMBV100B
566User Manual 1178.4460.02 ─ 03
11.4.3 GPIB Address Settings
Access:
1. Select "System Config > Remote Access > GPIB Address".
2. Set the GPIB channel address of the connected instrument.
Remote command:
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 898
11.4.4 RS232 Settings
Remote control via a serial interface is possible via a USB. The controller and the
instrument must be connected with the external USB/serial-adapter R&S TS1-USB
(see recommended extras in the data sheet) and a serial crossover (null modem)
cable. A USB connection requires the Visa library to be installed on the controller. Visa
detects and configures the R&S SMBV100B automatically when the USB connection is
established.
Access:
► Select "System Config > Remote Access > RS232".
In the "RS232" dialog, you can configure the settings of the serial interface.
The remote commands required to configure the settings remotely are described in
Chapter 12.17, "SYSTem Subsystem", on page 889.
Baud Rate
Sets the baudrate for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:BAUD on page 902
Parity
Sets the parity for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:PARity on page 902
Remote Access Settings
To Next Page
Loading...
