Rohde & Schwarz SMBV100B - How to Return to Manual Operation

Network Operation and Remote Control
R&S
®
SMBV100B
588User Manual 1178.4460.02 ─ 03
To activate the SCPI remote trace:
1. Start a web browser that supports HTML5 (W3C compliant).
2. Enter the IP address of the R&S SMBV100B in the browser's address bar.
The R&S SMBV100B's welcome page is displayed.
3. In the navigation pane, select "Diagnostics > SCPI Remote Trace".
4. In the toolbar bar of the "SCPI Remote Trace" page, select "live mode > on" and
"logging > on".
"live mode > on" displays all commands and responses, and "logging > on" also
traces messages.
If you now control the R&S SMBV100B with SCPI commands, using an appropriate
tool, the LXI function records the information sent and received.
The function records all sent commands, received responses and messages, and
saves them in an internal database. If "live mode" is disabled, you can display the
recent traces upon request, using the "refresh" button. You can also save the log in
a file.
Note: The diagnostics functionality will be extended in later releases, e.g. to down-
load or upload SCPI command files from / to the instrument.
11.10 How to Return to Manual Operation
Before returning to manual control, command processing must be completed. Other-
wise, the instrument switches back to remote control immediately.
1. To return from "Remote" state to manual state, perform one of the following:
● On the controller, use the command &GTL
Note: If &NREN has been set before &GTL is locked. Use &GTR instead.
● In the status bar, select the "Remote" icon.
● On the front panel, press the [Local] key.
● In the block diagram, select "Context sensitive menu > Key Emulation > Local"
2. To return from "Remote LLO" state to manual or to "Remote" state, perform one of
the following:
Note: In the local lockout state, the command &GTL and the [Local] key are locked.
You can unlock this state only via remote control.
● On the controller, use the command &LOCS.
This command switches directly to manual operation.
● Send the command &REMS.
This command changes the remote control state from "Remote LLO" to
"Remote".
● Use the Visual Basic command CALL IBLOC (generator%).
How to Return to Manual Operation