Getting Started
R&S
®
SMBV100B
40User Manual 1178.4460.02 ─ 03
Risk of network failure
Consult your network administrator before performing the following tasks:
●
Connecting the instrument to the network
●
Configuring the network
●
Changing IP addresses
Errors can affect the entire network.
To assign the IP address manually on the instrument
Use computer names to identify the instrument
In networks using a DHCP server, we recommend that you address the instrument by
its unambiguous computer name, see Chapter 2.1.4.2, "Using Computer Names (Host-
names)", on page 38.
1. Press the [Setup] key.
2. Select "Remote Access > Network".
3. Select "Address Mode > Static".
4. Select the "IP Address".
5. Enter the IP address, for example 192.168.0.1.
The IP address consists of four number blocks separated by dots. Every block con-
tains 3 numbers in maximum.
6. Select the "Subnet Mask" and enter the subnet mask, for example 255.255.255.0.
The subnet mask consists of four number blocks separated by dots. Every block
contains 3 numbers in maximum.
To assign the IP address manually on the computer
► Obtain the necessary information from your network administrator. If you use more
than one LAN connector, you need separate address information for each connec-
tor.
For information on how to perform the configurations, refer to the documentation of
the operating system the computer uses.
2.2 Instrument Tour
The following topics help you get familiar with the instrument and perform the first
steps:
●
Front Panel Tour
Instrument Tour
To Next Page
Loading...
