Rohde & Schwarz SMBV100B - Selftest Baseband Settings

Maintenance
R&S
®
SMBV100B
937User Manual 1178.4460.02 ─ 03
Log Message ← BNC Connections Test
Displays the log message reported during the BNC connections test.
Remote command:
:TEST:BB:BNC:LOG? on page 919
13.3.5 Selftest Baseband Settings
Access:
► Select "System Config > Setup > Maintenance > Selftest > Baseband".
In the "Baseband" dialog you can execute the baseband selftest.
The remote command required to start the test is described in Chapter 12.19, "TEST
Subsystem", on page 917.
Execute Baseband Selftest
Performs a baseband selftest.
The result (succeeded or failed) is displayed in the status field on the right.
Remote command:
:TEST:BASeband? on page 918
Log Message
Displays the log message reported during the baseband test.
Remote command:
n.a.
13.3.6 Selftest Test Generator Settings (DAC)
This function is password-protected. Unlock the protection level 1 to access it.
Performing Maintenance Tasks