Network Operation and Remote Control
R&S
®
SMBV100B
571User Manual 1178.4460.02 ─ 03
11.5.1 LXI Status Settings
Access:
► Select "System Config > Setup > Remote Access > LXI Status...".
The "LXI - Status" dialog shows the parameters of the LAN connection.
Alternatively, you can change the LAN settings using the LXI web browser interface,
see Chapter 11.5.2.1, "LAN Configuration", on page 573.
LAN Status
The LED indicates the LXI status.
"green"
Normal operation
"green (flashing)"
Device identification
"red"
LAN fault
Hostname / MAC Address / IP Address
See "Hostname" on page 563.
LAN Reset
Initiates the network configuration reset mechanism for the instrument and resets the
hostname, MAC address, and IP address.
According to the LXI standard, a LAN reset must place the following network settings
to a default state:
Parameter Value
TCP/IP mode DHCP + Auto IP address
Dynamic DNS Enabled
LXI Settings
To Next Page
Loading...
