Rohde & Schwarz SMBV100B - Trigger Settings

Remote Control Commands
R&S
®
SMBV100B
790User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt <Start>
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP <Stop>
Defines the first/last carrier in the carrier range to which joint configuration applies.
Parameters:
<Stop> integer
Range: 0 to 8191
*RST: 0
Example: See "Programming Examples" on page 779
Manual operation: See "Carrier Start/Stop" on page 245
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe <State>
Switches all the carriers in the selected carrier range on or off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example: See "Programming Examples" on page 779
Manual operation: See "Carrier State" on page 245
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute
Adopts the settings for the carrier range.
Example:
See "Programming Examples" on page 779
Usage: Event
Manual operation: See "Accept" on page 246
Trigger Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute.........................................................790
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute.................................................................791
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut................................791
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe?.................................................................791
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth................................................................. 791
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce................................................................. 792
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:DELay.....................................................792
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:INHibit.....................................................792
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence.............................................................793
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute
Stops signal generation.
Example:
See "Programming Examples" on page 779
SOURce Subsystem