Rohde & Schwarz SMBV100B - External Instrument Configuration Settings

Multi-Instrument Setups
R&S
®
SMBV100B
449User Manual 1178.4460.02 ─ 03
:SCONfiguration:EXTernal:DIGital:RF:FREQuency:OFFSet on page 670
:SCONfiguration:EXTernal:IQOutput:RF:FREQuency:OFFSet on page 670
:SCONfiguration:EXTernal:DIGital:RF:POWer on page 670
:SCONfiguration:EXTernal:IQOutput:RF:POWer on page 670
:SCONfiguration:EXTernal:DIGital:RF:POWer:OFFSet on page 671
:SCONfiguration:EXTernal:IQOutput:RF:POWer:OFFSet on page 671
RF State
With enabled "RF Coupled" parameter, displays the RF output state of the connected
external instrument. The parameter is coupled to the state of the RF output of the
R&S SMBV100B.
In uncoupled mode, enables/disables the RF output in the external instrument.
Remote command:
:SCONfiguration:EXTernal:DIGital:RF:STATe on page 671
:SCONfiguration:EXTernal:IQOutput:RF:STATe on page 671
8.5.2.2 External Instrument Configuration Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
The "<Dig. Conn. Name>: External Instrument Configuration" dialog opens and dis-
plays the "External Instrument Configuration > Remote Config" settings.
System Configuration Settings