Configuring the Internal Baseband Source
R&S
®
SMBV100B
212User Manual 1178.4460.02 ─ 03
3.7.3.5 Next Segment Trigger In Settings
The "Next Segment Trigger" settings are enabled only if a multi-segment waveform is
loaded into the ARB.
Access:
1. Enable and load a multi-segment waveform in the ARB, see Chapter 3.7.3, "Multi-
Segment Settings", on page 199.
2. Select "Baseband > ARB > Trigger In (MSW)".
The "Next Segment Trigger In" section comprises the settings necessary to adjust
the trigger for switching between the segments of a multi-segment waveform. The
parameters displayed depend on the selected trigger source.
Settings:
Current Segment/Current Segment Index...................................................................212
Segment......................................................................................................................213
Next Segment Mode................................................................................................... 213
Next Segment Source.................................................................................................214
Level Mode..................................................................................................................214
Execute Next Segment............................................................................................... 214
Sequencing List...........................................................................................................214
Trigger Example..........................................................................................................215
Current Segment/Current Segment Index
Indicates the waveform segment (segment filename and index) that is output.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment? on page 754
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NAME? on page 754
Generating Multi-Segment Waveform Files
To Next Page
Loading...
