Rohde & Schwarz SMBV100B - How to Save a Hardcopy of the Display

File and Data Management
R&S
®
SMBV100B
507User Manual 1178.4460.02 ─ 03
Remote command:
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix on page 646
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix:STATe on page 646
:HCOPy:FILE[:NAME]:AUTO[:FILE]:YEAR:STATe on page 645
:HCOPy:FILE[:NAME]:AUTO[:FILE]:MONTh:STATe on page 645
:HCOPy:FILE[:NAME]:AUTO[:FILE]:DAY:STATe on page 645
Current Auto Number ← Hardcopy Options > Automatic Naming
Indicates the number which is used in the automatically generated filename.
Note: When initially switching on the instrument, the number is reset to the lowest pos-
sible value. Starting with number 0 the output directory is scanned for existing files. As
long as files with the same name are existing, the number is increased by 1. The num-
ber is automatically set so that the resulting filename is unique within the selected path.
The current number is not in the save/recall file but is temporarily stored within the
database. At the following save operation, the number is increased.
Remote command:
:HCOPy:FILE[:NAME]:AUTO[:FILE]:NUMBer? on page 645
9.10.2 How to Save a Hardcopy of the Display
1. Select "System Config > Setup > User Interface > Hardcopy".
2. To define the output format, select "Format > JPG".
3. To enable the instrument to create output filenames, select "Automatic Naming >
On".
4. Select "Options...".
Creating Screenshots of Current Settings